Home Projects Science related Plants Watering Watcher

 

 

Plants Watering Watcher

source: RED Free Circuit Designs


Varying brightness LED signals the necessity to water a plant

Very low consumption, 3V powered circuit

 

Plants Watcher circuit diagram



Parts:

R1___________470K   1/4W Resistor
R2_____________3K3  1/4W Resistor
R3___________100K   1/2W Trimmer Cermet

C1_____________1nF  63V Polyester Capacitor
C2____________47F  25V Electrolytic Capacitor

D1__________1N4148  75V 150mA Diode
D2_____________5mm. Red LED

IC1___________4093  Quad 2 input Schmitt NAND Gate IC

P1,P2_______Probes  (See text)

SW1___________SPST  Slider Switch

B1______________3V  Battery (2 AA 1.5V Cells in series)



Device purpose:

This circuit is intended to signal when a plant is needing water. A LED illuminates at maximum brightness when the ground in the flower-pot is too dry: it dims gradually as the water's content in the pot grows, turning off when the optimum moisture's level is reached. This condition is obtained trimming R3.

Circuit operation:

IC1D forms a square wave oscillator with approx. 10/90 mark-space ratio. It feeds the output probe P1 and its signal, inverted by IC1A is compared with that picked-up by P2 in the NAND gates IC1B & IC1C in parallel, driving the LED. When a low resistance exists between the probes, due to an high water's content in the flower-pot, the LED is off, turning gradually on as the resistance between the probes increases.

Notes:

  • A square wave is used to avoid probes' oxidization.

  • Probes can be long nails, carbon rods obtained from disassembled exhausted 1.5V batteries, or even a couple of screwdrivers.

  • The probes must be driven in the pot's ground a few inches apart.

  • Due to 3V supply, the LED needs not a limiting resistor.

  • Power consumption: LED off = 50A; LED full on = 1mA.

  • To switch-off the circuit, you can short the probes. In this case SW1 can be omitted.

  • Using an high-efficiency LED, brightness variations are better emphasized. In this case a limiting resistor could be necessary.
     

Also check the conversation about this project at the community. Post you questions here.
 

 
 

 

Search Site | Support us | Advertising | Profile | Books | Gadgets | Add your link here | Contact Us


IQ Technologies @ copy right 2008

Powered by Wild Host   Site Design By : FRIEND